Pro 3 Bluetooth Gamepad FAQ
  • Does it support waking up the Switch 2?
    • No, it doesn't. The wake-up feature on Switch 2 only works with Joy-Con 2 or the Switch 2 Pro Controller.

  • If I map buttons to L4/R4 on the gamepad and then enable a software configuration, which takes priority?
    • The software configuration takes priority.

  • What joysticks are equipped on the Pro 3 Bluetooth Gamepad?
    • TMR Joysticks.

  • Is it possible for multiple controllers to pair and connect with one adapter?
    • No, each adapter can only support one controller connection at a time.

  • How to enable the “zero-dead zone mode on the joysticks”?
    • Please visit Ultimate Software V2 to make adjustments.

  • Instructions for calibrating the joysticks/triggers:
    • Please follow the steps below:
    • 1. Gamepad in the powered-on state, press and hold the “L1 + R1 + Select” buttons for 8 seconds to enter the calibration mode, the Status LED will start to blink.
    • 2. Push the joysticks to the edge and rotate them slowly 2–3 times. Slowly press the triggers to the bottom 2–3 times.
    • 3. Press the same “L1 + R1 + Select” buttons combination again to complete the calibration.

Submit